;)
FEATURES
Heavy duty bearings
High efficiency copper wound motor
In-built lip seal to prevent ingress of silt and sand
Float switch is provided upto 0.75 kw - 1ph
Sewage pump Can handle solids upto 15mm & dewatering pump Can handle solids up to 30 to 60mm
The relatively small size and weight make these pumps specially suitable for temporary services like dewatering of construction sites and for emergency services in case of flooding.
The pumps at equipped with a handle which makes it easy to move them from one point of application to the other.
Pumps are designed for free standing installation, but can also be permanently installed by means of an auto coupling guide rail system
Pumps in permanent installations can cope with PH-values ranging from 4 to 10.
Permissible Liquid temperature: 0° to 40°C
All pumps are supplied with 15 meters cable up 3 HP pumps & 20 meters cable upto 5 to 10 HP pumps
The stator windings incorporate temperature sensors (PTC Or TOP) which cut out the motor in case of over temperature. (Temperature sensors (PTC OR TOP) are built into the stator windings, and a contact in the sensors will open on case of over temperature i.e. 120 oc.)
SPECIFICATIONS
Power Range: 0.37 – 2.2kW (1 Phase) & 0.37 – 7.5kW(3 Phase)
Speed: 2900 RPM
Degree of protection: IP 68
Motor type: Dry
Impeller type: Semi-open, non-clog
Insulation type: Class F
Version Single Phase: 230V, 50Hz, A.C. Supply. Three Phase: 380 - 415V, 50/60Hz, A. C. Supply
Direction of rotation: Clock wise (when viewed from driving end)
Duty: S1 Continuous
MATERIAL OF CONSTRUCTION
Part Name: Material
Pump casing: Cast Iron
Motor frame: S.S. 304
Impeller:Cast Iron / Polyamide
Shaft: S.S. 420
Mechanical seal Dual Mechanical Seal Silicon Carbide and Carbon Ceramic